External temperature sensor

The external temperature sensor improves the measuring accuracy significantly.

The internal sensor is located directly on the PCB inside the housing of the APP-control. The measured temperature will be higher then the actual temperatur.
If the APP-control is mounted behind a cover, it will take a long time until the temperature inside the housing reaches the temperature of the passenger compartment.

The external sensor has a accuracy of 1 degree and can be mounted at a place where the actual temperature can be measured.

The external temperatur sensor is suitable for all DANHAG APP-control with 4-pin auxiliary connector.

configuration

After connecting the external temperature sensor, you still need to activate it.
To do this, send an SMS with the following content to the control unit in the vehicle:

12345;35=1;#

Scope of delivery

• DANHAG Temperature sensor, Connection cable ca. 100cm

NOTE
Vehicle manufacturers are constantly developing their vehicles further and making changes as part of model upgrades. Many vehicles are also available in countless equipment variants. We do not have the possibility to test our devices, connectors and wiring harnesses in all vehicles or equipment variants. It may happen that the devices we offer do not function as intended in some vehicle models or versions and / or cause error entries. In this case, we will take the device back. We will not reimburse any costs incurred for troubleshooting and installation.

By purchasing this item, you expressly declare that you have read, fully understood and accepted the above information.

The following section is only relevant for the APP control and radio remote control ‘T99’ offered by us.

POWER SUPPLY NOT INCLUDED
Directive (EU) 2022/2380 of the European Parliament and of the Council of 23 November 2022 amending Directive Directive 2014/53/EU on the harmonisation of the laws of the Member States relating to the making available on the market of of radio equipment on the market, the legislator has introduced an extended programme of obligations for distributors of electrical equipment such as mobile phones, tablets and the like. From 28.12.2024, or 28.04.2026 for laptops, laptops, two new labelling elements must be used to indicate whether a power supply unit is included in the included in the scope of delivery and which one is compatible.

On the basis of the above-mentioned directive, we hereby dutifully inform you that no power supply unit is included in the scope of delivery of the radio systems offered by us.

Furthermore, we hereby inform you that no power supply unit is required to operate the radio systems we offer. The power is supplied via the vehicle's electrical system. The list of compatible power supply units required by law is therefore not necessary.

Information in accordance with the EU Product Safety Regulation (GPSR)

Manufacturer information

The manufacturing information includes the address and related information of the manufacturer of the product.

DANHAG - Ing. Büro Gornicki
Danielle Gornicki
Zur alten Börse 77
12681 Berlin
Deutschland
E-Mail: info@danhag.de 

Person responsible for the EU

Economic operator established in the EU who ensures that the product complies with the required regulations.

DANHAG - Ing. Büro Gornicki
Danielle Gornicki
Zur alten Börse 77
12681 Berlin
Deutschland
E-Mail: info@danhag.de

Responsible person for non-EU

This information is not applicable, this product is not sold in countries outside the EU..

Authorised person (contact point) for product safety issues

DANHAG - Ing. Büro Gornicki
Danielle Gornicki
Zur alten Börse 77
12681 Berlin
Deutschland
E-Mail: info@danhag.de