DANHAG Y-cable Webasto Telestart

Y-cable to connect the DANHAG APP-control directly to an already existing telestart receiver.  The Y-cable provides the power supply of the APP-control as well as the connection to the heater.

As the the Telestart and APP-control is powered by the same power supply, you will have to change the fuse of the timer to 5 Ampere. 

Suitable for the following Telestart: 

• Webasto Telestart T91
• Webasto Telestart HTM100
• Mercedes (W-BUS)

Scope of delivery

• Y-cable DANHAG -> Telestart

Please note: The heater can be controled via W-BUS, E-BUS or CAN-BUS. This Y-cable can be used with W-BUS only. Please check which BUS you existing app-control use. You can find this information either at the lable of the app-control or at the end of the "INFO-SMS". 

Vehicle manufacturers are constantly developing their vehicles and making changes as part of the model update.
Many vehicles are also available in countless equipment variants.
We do not have the opportunity to test our devices in all vehicles or equipment variants.
It is therefore possible that the devices we offer may not function as intended in some vehicle models or versions and/or may function as intended and / or cause error entries.
In this case, we will of course take the device back.
We will not reimburse any costs incurred for troubleshooting, installation, etc.

Data according to 'EU-Produktsicherheitsverordnung (GPSR)'

Manufacturer

DANHAG - Ing. Büro Gornicki
Danielle Gornicki
Zur alten Börse 77
12681 Berlin
Deutschland
E-Mail: info@danhag.de 

Authorised person (contact point) for product safety issues

DANHAG - Ing. Büro Gornicki
Danielle Gornicki
Zur alten Börse 77
12681 Berlin
Deutschland
E-Mail: info@danhag.de

Safety instructions

DANGER TO LIFE !

This product is used to switch an existing parking heater with a mobile device (cell phone, tablet, etc.).
ATTENTION: Parking heaters cause toxic exhaust fumes during operation! NEVER operate the parking heater in closed rooms, there is an acute DANGER TO LIFE!

The app-control uses the Short Message Service (SMS) of the mobile phone operator to control the heater. The SMS messages are sent by the mobile network operator. Depending on the utilization of the mobile phone network and the reception quality at the location of the vehicle, it may happen that the SMS is delivered with a delay, that the SMS is delivered with a delay. In this case, the switching command is also implemented with a time delay.

GENERAL SAFETY INSTRUCTIONS

This product may only be used by persons who have reached the age of majority in accordance with the applicable law in the respective country within the scope of the EU Product Safety Regulation (GPSR) and are in full possession of their mental faculties and have fully read and understood the installation and operating instructions without outside help.

The product may only be installed and commissioned in the presence of a second, fully qualified and technically experienced person who has also read and fully understood the installation and operating instructions. and operating instructions and is able to provide immediate first aid in the event of danger.

Observe the generally applicable safety regulations. Wear suitable protective clothing during installation and commissioning, but at least the protective equipment prescribed by the employers' liability insurance association.

This product is connected in the vehicle with a connecting cable. There is a DANGER of getting caught on the cable, falling or strangulation.

This product is supplied with power via the vehicle battery. The power consumption depends on the mobile phone reception. In places with poor reception (e.g. underground car park), the power consumption is increased. Disconnect the product from the power supply if you do not use the vehicle for a longer period of time (2 weeks) to reduce the risk of a harmful deep discharge of the vehicle battery.

INTENDED USE

Only use the product for the intended use specified in the operating instructions. Do NOT use the product to switch devices that could be dangerous if the control unit malfunctions. In particular, DO NOT use the product for switching life support systems or in aerospace applications.

This product is NOT a toy.

This product contains small parts (SIM card holder, unlocking tool) that can be swallowed or inhaled. Ensure that the product is stored or installed out of the reach of children.

This product is NOT suitable for consumption. Traces of nuts and pulses may be present.

The DANHAG team is pleased that you have read this information in accordance with the EU Product Safety Regulation (GPSR). If you have any questions about product safety please contact our authorised person for product safety issues.